Telefon: +49 (0) 71 50 - 3 50 43-0 • Bestellannahme Mo.-Fr. von 8.00 - 18.00 Uhr 18 PROPANE • Soldering Hammer form Point form Cranked hammer form Version Part no. mm Part no. mm Part no. mm kg 250g 219/2 17x82x129 220/2 21x206x19 219/5 17x110x133 0.27 350g 208/2 22x81x131 209/2 22x215x22 208/5 17x110x136 0.37 500g 210/2 21x100x142 211/2 25x223x25 210/5 22x115x132 0.52 New design and faster warm-up! The same high product quality, a new design and a faster warm-up due to an increase in surface area on the underside of the soldering iron are the result of close cooperation with a plumbing company that we know well. Rigid positioning of the soldering iron The flattened rear face of the steel shaft prevents the soldering iron from turning away. Faster warm-up The core drill holes and the chamfered edges on the underside of the copper bit increase the surface area to be warmed up. This facilitates a better distribution of the heart of the torch flame and enables a faster warm-up. High thermal conductivity and retention due to cold-rolled electrolytic copper as base material. Due to the ideal thermal transfer of the electrolytic copper, the soldering iron heats up to operational temperature in less than 45 seconds – in addition the base material guarantees maximum thermal retention and thereby achieves a lower gas consumption when soldering. PERKEO 350 g-ZINNLUX-LONGLIFE copper bits New special coating New ZINNLUX-LONGLIFE soldering bits are covered with a special coating, which protects the copper core from aggressive soldering fluid and deposits on the surface. The shape of the soldering bit is retained for at least 2,500 solder metres – so no need for truing up or hammering. The extra coating makes the soldering bit significantly more maintenance-friendly and longer lasting. Complete tin coating of the iron is no longer required. To clean and care for it, all you need is a damp cloth. So long, salmiak stone. ZINNLUX LONGLIFE Conventional soldering bit Used solder parts after 100 hours of non-stop operation compared PERKEO Copper bits Hammer form Point form Cranked hammer form Version Part no. mm Part no. mm Part no. mm kg 350g 208/2/Z 22x81x131 209/2/Z 22x215x22 208/5/Z 17x110x136 0.37 New New • Operating temperature in less than 45 seconds • Lower gas consumption by maximum heat retention • No need for truing up or hammering • Flattened rear face of the steel shaft prevents from turning away • Cleaning without salmiak stone • Additional drillings at the bottom of the soldering bit increase the target area of the propane flame at over 1,000˚C and therefore provide faster heat transfer
RkJQdWJsaXNoZXIy ODY1MjQ=