HETTICH BENELUX Stability cabinets 9 8 Pharmaceutical, chemical and cosmetic products are subject to very stringent requirements for durability and stability. Hettich Benelux has manufactured ‘Pharmaceutical Stability Cabinets‘ (PSC) in-house for many years. All cabinets comply with the ICH Q1A directive. The stability cabinets are available in two standard versions, PSC 600 & PSC 1400. Other variations can be custom-made. Units can be placed together in any combination to make a complete wall with floor and ceiling finish. A wide variety of options and accessories are available. The PSCs have a small footprint and due to the unique air circulation system the entire shelf can be used as a validatable surface. For maximum energy savings the control systems have been programmed with a so-called ‘neutral zone‘. This is proportionally cooled or heated to the set value, followed by an energy-neutral interval in which no heating or cooling takes place. An ultrasonic air humidifier and a well insulated housing are used, this results in low energy consumption. Due to the unique air circulation system, an inner door on the PSC is not required. This makes all areas of the cabinet to be easily accessible. The optional drawers run on telescopic pull-out rails and the shelves are on fixed guides. The alarm and monitoring are clearly visible through a green and red LED light line on the front. Integration with our SYCL temperature registration system is optional. The stability cabinets are suitable for, among others, the following applications: • pharmaceutical stability; • cosmetics; • foods; • aging tests. HETTICH BENELUX Incubators 7 6 Hettich Benelux has manufactured Multi Purpose Cabinets (MPC) for several years. The MPC models are available as incubator, cooled incubator, refrigerator and freezer. There are 3 standard sizes, MPC 225/225, MPC 600 and MPC 1400. Other variants and sizes such as a pass through incubator can be delivered as custom unit. The MPC units do not need space on the sides to open the door. As the door on the MPC does not increase the width of the unit, MPC units can be placed almost anywhere, in a corner or directly next to other laboratory equipment. This also offers possibilities to build a complete wall when multiple incubators, coolers or freezers are placed next to each other. The wall is then of course neatly finished, from floor to ceiling. The alarm and monitoring are clearly visible through a green and red LED light line on the front. Integration with our SYCL temperature registration system is optional. The internal guide system, drawers and shelves are made of stainless steel and can very easily be taken out to thoroughly clean the interior. Minimal dehydration by application optimal air circulation system. The MPC units have unique properties such as • a very low noise level; • reduced energy consumption; • a homogeneous temperature in the cabinet; • a unique air circulation system; • a very favourable work surface/floor area ratio. Due to the wide variety of options and accessories, the MPC can be assembled according to your wishes. In addition to standard models, we also produce tailor-made reach-in and roll-in incubators. Depending on the application we can build in a simple controller or a touch screen controller.
RkJQdWJsaXNoZXIy ODY1MjQ=